       
 |
      
"X", &"X-2" SERIES BOATS
In the summer of 2004, Pro-Drive introduced their “X” series boat line. It was their goal to introduce a shallow draft boat to compliment shallow draft outboards. After running many different hunting boat designs, Pro-Drive discovered that a square chime boat runs higher and drafts less water in every condition which, in turn, produces better speeds and higher load carrying capabilities. The square chime and smooth bottom gives the consumer the best maneuvering capability when running at idle or low speeds. Therefore, the “X” Series boat line has emerged.
Pro-Drive is very proud to have been the first in the industry to bring you a seat/gun box which can be positioned in any of six different locations or can be removed completely.
Pro-Drive’s “X2” Series boats come with floatation. Although, interior design is limited due to the floatation restrictions, the exterior design is exactly the same as the “X” Series. These boats are not only a great compliment to Pro-Drive’s shallow water outboards but are also great for all other small outboards.
Knowing that hunters and fisherman run in areas where they will have to cross logs, stumps and bottoms which can damage the bottom of most light duty hulls and because of its commitment to quality, Pro-Drive constructs all of its boats with 5086 grade aluminum which is .125 thick. With experience from building airboat hulls in the past, Pro-Drive knew that in extreme environments, a boat that has ribs running across the width of its bottom tends to buckle in between the ribs. Therefore, Pro-Drive runs 1” x 2” rectangular ribs across the length (front to back) of all their boats. That along with 2” X 2” square tubing bracing the floor and side walls make it almost indestructible.
Our custom boats come with many of the standard features that other manufacturers add on as options. Although their prices may seem less expensive on a base boat, once options that Pro-Drive offer as standard are included, they are much more expensive in most cases.
So, if you are in the market for an easy to operate, durable and dependable shallow water motor or draft boat which emulates top performance, the staff at Pro-Drive recommends contacting our dealer nearest you or Pro-Drive Outboards at 337-229-0034. All Pro-Drives are “Built Tough! Built for Life!” and it is our goal to ensure customer satisfaction. |
MATERIALS
- .125 ALUMINUM BOTTOM AND SIDES
- 1" X 2" RECTANGULAR TUBING FOR RIBS WHICH FOLLOW THE FULL LENGTH OF THE BOAT.
(FIVE (5) RIBS ARE USED ON THE 48" MODELS AND SIX (6) RIBS ARE USED ON THE 54" MODELS.
- 2" X 2" SQUARE ALUMINUM TUBING IS USED FOR BOTTOM AND SIDE SUPPORTS.
- 2" X 3" ALUMINUM CHANNEL BUTTED TOGETHER MAKE UP THE TRANSOM FOR UNBEATABLE TRANSOM STRENGTH
|
|
STANDARD FEATURES INCLUDED
- 4' TOP DECK WITH HATCH INSIDE
- SUB FLOOR WITH NON SKID PAINT
- REAR SEAT WITH STORAGE AND UTILITY TRAY INSIDE
- MULTI POSITION SEAT / GUN BOX
- RUNNING LIGHTS WITH ANCHOR LIGHT BRACKET MOUNTED FOR STORAGE.
- GAS TANK BRACKET
- BATTERY TRAY WITH TIE DOWN EYES.
- TRANSOM UTILITY TRAY
- PRO-DRIVE DUCK BOAT GREEN PAINT
|
|
"X" BOAT SIZE |
PRICE |
| 16 X 48 (18" SIDES) |
$4,520.00 |
| 17 X 48 (18" SIDES) |
$4,620.00 |
| 18 X 48 (18" SIDES) |
$4,720.00 |
| 20 X 48 (18" SIDES) |
$4,920.00 |
| |
|
| 16 X 54 (21" SIDES) |
$4,820.00 |
| 17 X 54 (21" SIDES) |
$4,920.00 |
| 18 X 54 (21" SIDES) |
$5,020.00 |
| |
|
| 17 X 60 (18" SIDES) |
$4,920.00 |
| 18 X 60 (18" SIDES) |
$5,020.00 |
| 20 X 60 (18" SIDES) |
$5,220.00 |
| |
|
| 17 X 60 (21" SIDES) |
$5,420.00 |
| 18 X 60 (21" SIDES) |
$5,520.00 |
| 20 X 60 (21" SIDES) |
$5,720.00 |
|
"** Please note that ALL ""X"" Series Boats are Commercially Rated " By the US Coast Guard and have no floatation.
STANDARD FEATURES INCLUDED
- 4' TOP DECK WITH NON SKID PAINT
- FULL FLOOR WITH NON SKID PAINT
- REAR SEAT WITH STORAGE AND UTILITY TRAY INSIDE
- RUNNING LIGHTS
- GAS TANK BRACKET
- BATTERY TRAY WITH TIE DOWN EYES.
- 20" TRANSOM STANDARD
- PRO-DRIVE DUCK BOAT GREEN PAINT.
|
"X-2" BOAT SIZE |
PRICE |
| 16 X 54 (21" SIDES) |
$4,895.00 |
| 17 X 54 (21" SIDES) |
$4,995.00 |
| 18 X 54 (21" SIDES) |
|
|
STANDARD FEATURES INCLUDED
- 4' TOP DECK WITH NON SKID PAINT
- SUB FLOOR WITH NON SKID PAINT
- REAR SEAT WITH STORAGE AND UTILITY TRAY INSIDE
- RUNNING LIGHTS WITH ANCHOR LIGHT BRACKET MOUNTED FOR STORAGE.
- GAS TANK BRACKET
- BATTERY TRAY WITH TIE DOWN EYES.
- TRANSOM UTILITY TRAY
- PRO-DRIVE DUCK BOAT GREEN PAINT.
- FLOATATION
|
|
"X-2" BOAT SIZE |
PRICE |
| 16 X 48 (18" SIDES) |
$4,645.00 |
| 17 X 48 (18" SIDES) |
$4,745.00 |
| 18 X 48 (18" SIDES) |
$4,845.00 |
| |
|
| 16 X 54 (21" SIDES) |
$4,845.00 |
| 17 X 54 (21" SIDES) |
$4,945.00 |
| 18 X 54 (21" SIDES) |
|
|
ACCESSORIES & OPTIONS
MODEL # |
ITEM - DESCRIPTION |
|
Price |
| CNSL |
Center Console for single or dual engine boats
(Top Grab Bar not included) |
 |
$295.00 |
| TRL-MTR-BK |
Trolling Motor Bracket - Either side
|
 |
$50.00 |
| CNSL |
Side Console for single or dual engine boats
|
 |
$295.00 |
| PD-335 |
7' Rod Box With stainless steel spring hinges. - This box can go on the right, left, center, or be completely removed when not in use. |
 |
$295.00 |
| PD-324 |
Spotlight Kit - This spotlight kit is removable, and fully adjustable. Come with two 55 watt halgen bulbs. Picture 2 shows the spotlight kit flipped back inside the boat to provide lighting inside the boat. Comes complete with quick plug, wire, and mounting hardware. |
 |
$175.00 |
| EXT-DK(48/54) |
Extended Deck - Adds 14" to top deck surface to cover gas tank, trolling motor battery, or just extra covered storage.
|
 |
$175.00 |
| Boat Accy |
Multi-Postion Seat / Gun Box - This box is a six position box that has three positions length ways and three postions across and can be moved in minutes with two quick thread thumb screws. It can also be removed completely if needed |
 |
$275.00 |
| Boat Accy |
Rear Drivers Seat -This box has interior storage with a tray inside for those smaller hard to find items. |
 |
$192.00 |
| Boat Accy |
Bowfish Deck - Removable deck with rails. Rails can be custom made to any height.
|
 |
$695.00 |
| DK-RAIL |
Deck Rails
|

|
$150.00 |
| |
|
|
|
| PART # |
OPTION |
RETAIL |
| CNSL |
Console |
$295.00 |
| DK-RAIL |
Deck Rails |
$150.00 |
| EXT-DK(48/54) |
Extended Deck |
$175.00 |
| Boat Accy |
20" Transom |
$90.00 |
| Boat Accy |
21" Sides on 48" Boat |
$375.00 |
| Boat Accy |
Additional Rear Drivers Seat |
$192.00 |
| PD-233 |
Additional Multi-Position Seat (48") |
$275.00 |
| PD-233A |
Additional Multi-Position Seat (54") |
$275.00 |
| PD-335 |
7' Rod Box |
$295.00 |
| PD-305 |
12v Accy. Plug |
$40.00 |
| TRL-MTR-BK |
Trolling Motor Bracket |
$50.00 |
| PD-306 |
Trolling Motor Plug Set |
$55.00 |
| PD-318 |
Spud Kit |
$175.00 |
| PD-324 |
Spotlight Kit |
$175.00 |
| PED-SEAT |
Pedestal Seat Base (Your Location) |
$70.00 |
| POL-PLAT(48/54) |
Poling Platform |
$450.00 |
| PT-BOW(48/54) |
Pointed Bow |
$195.00 |
| Boat Accy |
Bowfish Platform |
$695.00 |
| PD-221 |
Push Pole |
$95.00 |
| PD-231 |
6 Gal. Gas Tank |
$35.00 |
| GT-BK |
Additional Gas Tank Bracket |
$28.00 |
| BAT-TRAY |
Additional Battery Tray |
$28.00 |
| PD-241 |
Primer Bulb |
$8.25 |
| PD-304 |
Battery |
$75.00 |
| PD-304A |
Battery Box |
$16.00 |
| Boat Accy |
Bildge Pump |
$80.00 |
| Boat Accy |
Automatic Bildge Pump |
$145.00 |
| Boat Accy |
Split Bench w/ Storage (X2 Model Only) |
$350.00 |
| Boat Accy |
Gun Box (X2 Model Only) |
$200.00 |
| |
|
|
| CUSTOM CAMO INCLUDES COMPLETE BOAT INSIDE AND OUT, INCLUDING SEATS |
| Boat Accy |
Custom Camo on 16' - 18' x 48" Boat |
$475.00 |
| Boat Accy |
Custom Camo on 16' - 18' x 54" Boat |
$525.00 |
| Boat Accy |
Custom Camo on 18' - 20' x 60" Boat |
$635.00 |
| |
|
|
| BASIC CAMO INCLUDES COMPLETE BOAT OUTSIDE OF BOAT AND TOP DECK |
| Boat Accy |
Basic Camo on 16' - 18' x 48" Boat |
$275.00 |
| Boat Accy |
Basic Camo on 16' - 18' x 54" Boat |
$325.00 |
| Boat Accy |
Basic Camo on 18' - 20' x 60" Boat |
$435.00 |
| |
|
|
| TRAILERS |
| Majic Tilt |
|
|
MODEL:
ALS-16-17
175X13B
1700# NET CARRYING CAPACITY |
FEATURES INCLUDE:
* CUSTOM FITTED TO MATCH YOUR BOAT * FITS 16'-18' BOATS WITH 48"-54" BOTTOMS
* ALL WELDED ALUMINUM I-BEAM FRAME & CROSSMEMBERS
* WINCH STAND WITH H/D WINCH & WINCH STRAP
* "LED" LIGHTS W/ WELDED ALUMINUM TAILLIGHT BRACKETS
* HEAT SHRINK WIRE CONNECTORS * ALUMINUM TREAD PLATES FENDERS
* GALVANIZED TUBE AXLE & DACROMET HUBS
* GALVANIZED SPOKED WHEELS * S/S BEARING PROTECTORS & BRA'S
* LOW PROFILE FITTED BUNKS FOR EASE OF LAUNCHING * FOUR 2" X 4" FULLY CARPETED TREATED BUNKS
* 2" X 4"X 6' SIDE GUIDE BOARD KIT
* SWIVEL JACK W/LARGE WHEEL * 2" BALL COUPLER
* SPARE B135 X 13B W/T MOUNTED * SPARE CARRIER W/LOCK
* 2 YEAR WARRANTY |
$1478.00 |
| |
|
|
| MCCLAIN |
|
$1,551.00 |
| 60" Width |
Galv. Trailer w/ side boards, dolly wheel & spare |
$1,551.00 |
| |
|
|
| ** ALL PRICES ARE SUBJECT TO CHANGE ** |
YOU WILL LOVE THE MULTI-POSITION BENCH SEAT / GUN / STORAGE BOX WHICH CAN BE POSITIONED IN ANY OF 3 PLACES LENGTHWISE, ANY OF 3 PLACES ACROSS, OR CAN BE TOTALLY REMOVED FROM THE BOAT IF DESIRED. THIS MULTI-POSITION SEAT/GUN/STORAGE BOX CAN ALSO BE ORDERED TO USE ON YOUR STANDARD "X" SERIES BOAT. THE 2" X 2" BRACING SYSTEM, WHICH IS UTILIZED ON ALL OF OUR BOATS, ALLOWS THE MULTI-POSTION SEAT TO FIT INTO ANY MODEL. WE DO NOT KNOW OF ANY OTHER BOAT MANUFACTURER WHO OFFERS THIS FEATURE. |
STANDARD FEATURES
- McCLAIN TRAILERS GALVANIZED FRAME13" and 14" TIRESBUDDY BEARINGSDOLLY JACK WITH WHEELSWINCH STAND ITH WINCHCARPETED BUNKS GALVANIZED AXLE AND WHEELS GALVANIZED FENDERS
- SUBMERSIBLE LIGHTS
|
|
|
|